Drilling Porcelain Tiles : The How To Guide

by Wall Tiles Online on 2:38 am

Drilling Porcelain Tiles : Step-By-Step Guide

Want to understand how is drilling porcelain tiles carried out? This post will aid you by providing simple steps that would be most important for your drilling pursuit. Drilling porcelain tiles will be needed if you want to set up extra accessories in your bathroom or any room that features porcelain tiles. For example, by drilling the porcelain tiles, you’ll be equipped to put bathroom shaving cabinet, a mirror, soap dish, towel rails, or maybe your cosmetics holder.

To get you started your drilling activity, you should first determine what type of supplies you should have in order to do the work. Here are the instruments you’ll need:

RCD Breaker

Drill Bits of Diamond Core (Good Quality)

Masonry Drill Bits (Included w/ quality drill bits)

Drill Bit of Carbide Pilot ( use this if you’ll drill 13-mm hole or bigger holes)

Equipment for Water Cooling

Drilling Device

Safety Glasses or Goggles

These materials could be bought in different stores. You can just simply purchase these before proceeding with your drilling activity. You have to make sure of the grade of the instruments first so that the output of the drilling can be ideal for your need.

Another thing that you should think about with drilling porcelain tiles is the hole sizes you are about to create. It is fairly important for the size or diameter of the hole will determine how big the drill bit you are about to use.

After establishing the diameter of the holes you’re going to drill and setting up the tools you’ll need for the drilling, you can start to proceed drilling porcelain tiles. Make sure you don your safety goggles to keep your eye clear of debris and prevention of electric shock with RCD.

These proceeding steps would be for holes about 10mm or less in diameter using diamond cores.

1. Put an indicator to the hole’s center. Either you use a sticky tape or simply a lead pencil.

2. Find the right size of the diamond core bit. After that, attach it to the electric drill. Ensure that there’s a supply of water from any cooling equipment is at a constant. (Water cooling equipment is essential in keeping it certain that there’s a constant cool temperature in the diamond core bit and will also prevent debris as you are drilling the hole. Avoid using handheld aspirator or wet sponge, for these do not provide enough coolant to the diamond core bit.)

3. Your drill must be positioned between 1000 & 1500 rpm. Choosing the marker as a marking tool, it’s most appropriate to use the “Leaning In” method.

*Method of Leaning In- With an angle, you’ll begin to drill. As you see the drill cuts the tile, your drill has to be in horizontal position. Make sure that there is sufficient pressure applied and turn the drill till the hole is completely drilled.

*Method using Sticky tape- Place sticky tape on the wall just where you want the hole. It will help to stop the drill bit from sliding.

4. Tip- I received a great from www.tfo.com.au. Once the hole has started, don’t use too much pressure have the drill carry out the work.

{ 0 comments… add one now }

Leave a Comment

Previous post:

Next post: